Xeros Vacuum Bed UV Exposure Unit
The Professional Choice
The Xeros range of vacuum bed UV units
feature an attractive low profile aluminium case, and
are fitted with an advanced electronic timer controller.
The timer is controlled from a touch membrane panel
that includes a digital display which reads from 0 -
999 seconds.
The lid is raised and lowered with the
assistance of internally fitted gas struts, and a safety
cut out device is incorporated to prevent the tubes
from operating when the lid is raised. Mains power is
introduced via a fused I.E.C panel mounted socket, which
incorporates a separate double pole ON/OFF rocker switch.
Operation of the unit is simple. Set the
time in seconds, close the lid and press the start button.
An integral vacuum pump then begins and first removes
the air from the chamber to ensure perfect contact between
artwork and material to be exposed. After vacuum has
been achieved, the exposure cycle begins. During exposure,
the timer counts down and once the cycle is complete,
the display returns to the original setting, an exposure
complete light illuminates, and a buzzer sounds for
3 seconds. (Note that the lid can only be released once
a valve releases the vacuum.) The exposure complete
light will remain on until the lid is lifted, which
acts as a safeguard against the possibility of double
exposure cycles.
The Xeros range incorporates a model that
can be used to manufacture liquid polymer based rubber
stamps. This facility is over and above the units normal
ability to process UV sensitive plate materials. This
machine is presently available only with a working area
of 37 x 60 cm.
The Xeros range of UV units should be
purchased when fine detail or photographic reproduction
is required. Where this is not the case, the Axos range
will prove more than adequate. The Axos range uses the
same slimline case and electronic control system as
Xeros, but the machines are configured as pressure pad
units rather than vacuum devices (the vacuum bed is
replaced by a large piece of foam which compresses against
the glass once the lid is closed).
If you
would like to view the Xeros 321R rubber stamp making
UV exposure unit, please follow this link.
The standard specifications of the Xeros range
are as follows.
| |
Xeros 315 |
Xeros 321/R |
Xeros 360 |
Xeros 380 |
| Working area |
33 x 36 cm |
37 x 60 cm |
57 x 68 cm |
52 x 92 cm |
| UV output |
6 x 15 watt |
6 x 20 watt |
10 x 20 watt |
12 x 20 watt |
| Dimensions |
55 x 48 x 17 cm |
72 x 58 x 17 cm |
76 x 73 x 17 cm |
89 x 103 x 21 cm |
| Weight |
17 kg |
27 kg |
34 kg |
90 kg |
| Timer |
999 seconds |
999 seconds |
999 seconds |
999 seconds |
- Produce water and solvent washable pad printing
plates with the Xeros range
- Produce water washable hot foil printing plates
with the Xeros range
- Process the ID-MARK imaging system with the Xeros
range
- Produce PCB's with the Xeros range
- Produce glass engraving stencils with the Xeros
range
| 
